SMR Gearbox Set up
Satisfactory performance relies on good set up. lubrication and maintenance. therefore it is vital the directions while in the installation and servicing leaflet. provided with each gearbox. are followed very carefully. a few of the critical facets of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as shut towards the reducer doable, and mount reducer on driven shaft as near to bearing as sensible. failure to do this will trigger excess loads within the input shaft bearings and output bearings and could induce their premature failure.
two. Install motor and wedge belt drive together with the belt pull at around 90° to your center line involving driven and input shafts. this will permit tensioning from the wedge belt drive with the torque arm which need to ideally be in stress. if output hub runs anti-clockwise. torque arm needs to be positioned the right.
3. lnstall torque-arm fulcrum on the rigid support so that the torque-arm will likely be at about right angles towards the center line through the driven shaft plus the torque arm case bolt. ensure that there exists sufficient get up within the turnbuckle for belt stress adjustment.
Keep near.
Bell drive may be located in any convenient postion. in the event the torque arm is always to be made use of to tighten the belts, the drive ought to be at about tight angle on the line amongst the input and output shafts.
Bell drive could possibly be positioned to the proper if sought after.
If output hub rotates clock-wise. place belt drive and torque arm in opposite route to that shown in the illustration.
Torque arm and belt consider up.
Torque arm can be mounted towards the suitable if sought after.