Electrical power UNITS FOR LIFT TABLE one
Basic Description
This energy unit is made solely for that little lift table,Consisting of substantial pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit continues to be broadly applied in the business of logistic gadgets for instance minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled through the solenoid valve with the pace managed from the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Standard Description
This electrical power unit is built solely to the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve plus the velocity managed through the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is minimize, the lowering movement is managed by the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is created solely for that massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve as well as velocity managed by a pressure compensated flow handle valve.
Electrical power UNITS FOR LIFT TABLE 4
Basic Description
This energy unit is intended solely for the huge lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as the pace managed from the adjustable needle valve. Once the lift rises to a large positoin, but the energy supply is cut, the lowering movement is controlled by the guide override function.
Specific Notes
one. This electrical power unit is of S3 duty cycle, which can only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned ahead of installation of the power unit.
3. Viscosity on the oil shoud be 15~46 cst,which should also be clean and free of impurities.N46 hydraulic oil is advised.
four. Oil changing is required after the original 100 operation hrs,afterwards after each 3000 hrs.
5. The electrical power unit shown is created to be mounted vertically.